Technical Innovations Circular Skirt - HD10
Same as the Rectangular Skirt, except a four piece skirt which ends in a circle 10'8" in diameter with drip flange. Useful in transition to a circular or octagon building, or to keep water away from a circular foundation.
The CS forms a complete circle 10 ft. 8 in. with a drip flange 1 in. high. The CS has a horizontal ring flange of about 3 in. radial width, with an ID of 113 in. The CS is provided in four sectors.
Each sector has a lip that overlaps the adjacent sector. The lips are caulked and bolted together with a single carriage bolt (1/4-20x3/4). A typical installation on a circular building or wall should provide for the
bottom flange of the HOME-DOME base ring to be 4 in. above the "rim" or edge of the building. The CS horizontal flange is then mounted beneath the base ring, so that the base ring foundation bolts hold the CS in place. Holes may be drilled in the circular skirt that fit onto the foundation bolts, and the base or wall ring will then rest on the skirt. Alternatively, some of the CS holes may be prepared as slots, so that the skirt can be slid under the base or wall ring. Since the CS sections cover 90 degrees of arc, the slots will generally not be on a radius, but at an angle to the radius.
In some installations, it may not be possible to mount the CS with its
horizontal flange beneath a base or wall ring flange. This will be the case where the HOMEDOME cannot be raised four inches above the roof edge to be matched. In this case, some or all
the CS horizontal ring flange may be removed, leaving a circular edge on the inside of the circular skirt. This edge would then be fitted against the outside surface of the base or wall ring. To assure that the resulting fit of the skirt to the wall/base ring will be as good as possible, you need to measure and cut with care. It is best to use a section of base ring as a guide for marking the circle, but you MUST have the skirt at the proper angle to the base/wall ring surface or your measurement will be incorrect.
Technical Innovations Product Number: CS10
To save on added expenses, this product will be drop shipped from the manufacturer. Shipping costs listed here are estimates only and an accurate figure will be given to you at the time of your order. Thank you!